Adding audio to an m3pi with a SpeakJet

Posted by Jamee on 5 September 2013

In this video, Jerry Guttman shows off his Pololu m3pi Robot combined with the SpeakJet Phraselator Speech Development System. The SpeakJet chip was developed by Magnevation and allows for speech synthesis and robot sound effects.

Featured link: http://www.youtube.com/watch?v=dYWQB12Ibsw

0 comments

Post a comment

Using your Pololu account allows you to customize your avatar and manage your comments; you can also post anonymously.

New Products

Glideforce GF01-120501-1-66 Micro Linear Actuator with Limit Switches: 12V, 2.2kgf, 28mm/s, 10mm Stroke
QTRX-MD-01A-S Reflectance Sensor: 1-Channel, 8mm Wide, Analog Output, Low Current, Side-Entry Connector
JST PH-Style Cable, 6-Pin, Female-Female, 10cm
5V, 600mA Step-Down Voltage Regulator D24V7F5
ACS72981ELRATR-200B3 Current Sensor Compact Carrier -200A to +200A, 3.3V
TB67H453FNG Single Brushed DC Motor Driver Carrier
JST PH-Style Cable, 4-Pin, Female-Female, 63cm
A89301-Based Sensorless Brushless Motor Controller, 50V, 11A
Pololu Reverse Voltage Protector, 4-60V, 10A
QTRXL-MD-01RC-S Reflectance Sensor: 1-Channel, 8mm Wide, RC Output, Long Range, Side-Entry Connector
Log In
Pololu Robotics & Electronics
Shopping cart
(702) 262-6648
Same-day shipping, worldwide
Menu
Shop Blog Forum Support
My account Comments or questions? About Pololu Contact Ordering information Distributors