Small things in the pipeline

Posted by Ben on 4 September 2013

Here’s a sneak peek at some encoder wheels we are developing for our micro metal gearmotors:

2 comments

When are you going to realese this?
Hello.

We have what should be a final configuration for the corresponding sensor board, so we just have to do initial production and make the product web pages and documentation. We should have that done by the end of the week.

- Jan

Post a comment

Using your Pololu account allows you to customize your avatar and manage your comments; you can also post anonymously.

New Products

0.100" (2.54 mm) Breakaway Male Header: 1×40-Pin, Straight, Red
Hakko 611 Solder Reel Stand (solder not included)
RoboClaw 2x15A Motor Controller (V5)
Breakout Board for microSD Card with 3.3V Regulator and Level Shifters
0.100" (2.54 mm) Low-Profile Male Header: 2×7-Pin, 8.75 mm
PIR Motion Sensor
0.100" (2.54 mm) Breakaway Male Header: 3×40-Pin, Right Angle
MAX14870 Single Brushed DC Motor Driver Carrier
Screw Terminal Block: 2-Pin, 0.1″ Pitch, Side Entry (4-Pack)
30:1 Micro Metal Gearmotor HPCB
Log In
Pololu Robotics & Electronics
Shopping cart
(702) 262-6648
Same-day shipping, worldwide
Menu
Shop Blog Forum Support
My account Comments or questions? About Pololu Contact Ordering information Distributors