Voltage Regulators and Power Supplies » Step-Up/Step-Down Voltage Regulators » S9V11x Step-Up/Step-Down Voltage Regulators »
5V Step-Up/Step-Down Voltage Regulator S9V11E2F5
| Output voltage | Typical max output current1 | Input voltage range | Low-voltage cutoff | Size |
|---|---|---|---|---|
| 5 V | 1.7 A | 2 V – 16 V (3 V startup) |
– | 0.43″ × 0.65″ × 0.16″ |
Note 1: For input voltages close to the output, after startup. Startup current is limited to approximately 700 mA until output voltage reaches the nominal voltage. After startup, the actual achievable maximum continuous current is a function of input and output voltage and is limited by thermal dissipation. See the output current graphs on the product page for more information.
Alternatives available with variations in these parameter(s): output type low-voltage cutoff Select variant…
Compare all products in S9V11x Step-Up/Step-Down Voltage Regulators.
| Description | Specs (12) | Pictures (10) | Resources (0) | FAQs (0) | On the blog (0) | Distributors (0) |
|---|
Dimensions
| Size: | 0.43″ × 0.65″ × 0.16″ |
|---|---|
| Weight: | 0.7 g |
General specifications
| Minimum operating voltage: | 2 V1 |
|---|---|
| Maximum operating voltage: | 16 V |
| Continuous output current: | 1.7 A2 |
| Output voltage: | 5 V |
| Reverse voltage protection?: | N |
| Maximum quiescent current: | 0.3 mA3 |
| Low-voltage cutoff: | none |
| Output type: | fixed 5V |
Identifying markings
| PCB dev codes: | reg20c, reg20d |
|---|---|
| Other PCB markings: | 0J16258, 0J16318 |
Notes:
- 1
- Note: the minimum startup voltage is 3V, but the regulator can operate down to 2V after startup.
- 2
- Under typical conditions, where the input voltage is close to the output voltage. Actual achievable continuous output current is a function of input voltage and is limited by thermal dissipation. See the output current graph under the description tab for more information.
- 3
- While enabled with no load. See the quiescent current graph under the description tab for more information. Can be reduced to less than 10 µA per volt on VIN using the enable pin.
Related products
Related categories
Home | Forum | Blog | Support | Ordering Information | Lists | Distributors | BIG Order Form | About | Contact
© 2001–2026 Pololu Corporation
