These premium stranded wires with pre-crimped male or female terminals are equivalent to our premium jumper wires without the 1×1 crimp connector housings on the ends. By combining these wires with our crimp connector housings, you can quickly and easily create custom cables with 0.1″ (2.54 mm) connectors that mate with various 0.1″-spaced connectors and solderless breadboards. Just pick the housing for the correct number of pins, pick the colors and genders for your wires, and snap them into the housings. No soldering is required!

The wires are available in eight lengths—1″ (2.5 cm), 2″ (5 cm), 3″ (7.5 cm), 6″ (15 cm), 12″ (30 cm), 24″ (60 cm), 36″ (90 cm), and 60″ (150 cm)—and up to ten colors:

• black
• brown
• red
• orange
• yellow
• green
• blue
• purple
• gray
• white

These are the same colors as those used on resistor color codes and rainbow ribbon cable. The available color options and pack sizes depend on the wire length, as does the wire gauge:

length	single-color pack quantity	multi-color pack quantity	gauge (AWG)
1″ (2.5 cm)	10 (six colors available)	60 (10 each of six colors)	26
2″ (5 cm)	10 (six colors available)	60 (10 each of six colors)	26
3″ (7.5 cm)	10 (six colors available)	50 (5 each of ten colors)	26
6″ (15 cm)	10 (ten colors available)	50 (5 each of ten colors)	26
12″ (30 cm)	10 (ten colors available)	50 (5 each of ten colors)	26
24″ (60 cm)	5 (ten colors available)	50 (5 each of ten colors)	26
36″ (90 cm)	5 (ten colors available)	20 (2 each of ten colors)	22
60″ (150 cm)	2 (ten colors available)	10 (1 each of ten colors)	22

The single-color packs of the 1″, 2″, and 3″ wires are only available in six colors (black, red, yellow, green, blue, and white); the single-color packs for all of the other wire lengths are available in all ten colors. The multi-color packs of the 1″ and 2″ wires have ten each of six colors (black, red, yellow, green, blue, and white); the multi-color packs for all of the other wire lengths, including 3″, have various quantities of all ten colors.

These wires can be purchased with male terminals on both ends (M-M), female terminals on both ends (F-F), or one male and one female terminals (M-F). These crimped terminals are designed for use with 0.1″ (2.54 mm) male headers and female headers, solderless breadboards, and prototyping PCBs. Note that we also sell the male and female crimp pins by themselves if you want to crimp your own wires. Close-up pictures of the male and female terminations are shown below:

You can use the following selection boxes to get to the specific wires you are looking for:

For versions of these wires with 1×1 housings already installed, see our premium jumper wires.

Compare all products in this category

---

Related Products

Related Categories

Log In

(702) 262-6648
Same-day shipping, worldwide