Motion Control Modules » Stepper Motor Drivers » MP6602 Stepper Motor Driver Carriers »
MP6602 Stepper Motor Driver Carrier
This is a breakout board for the MPS MP6602 microstepping bipolar/unipolar stepper motor driver, which features a serial interface and stall detection. It operates from 4.5 V to 35 V with a maximum current limit of 4 A, which it can run at continuously on our carrier board without a heat sink or forced air flow. The SPI interface allows configuration of the current limit, step mode (6 step modes from full-step through 1/32-step), decay mode off time, and stall detection, and it can also be used for stepper motor control. The driver also features built-in protection against under-voltage, over-current, and over-temperature conditions. This version does not include header pins.
Alternatives available with variations in these parameter(s): header pins soldered? Select variant…
Compare all products in MP6602 Stepper Motor Driver Carriers or 16-pin Stepper Motor Drivers.
| Description | Specs (14) | Pictures (8) | Resources (6) | FAQs (4) | On the blog (0) | Distributors (0) |
|---|
Dimensions
| Size: | 0.6″ × 0.8″ |
|---|---|
| Weight: | 1.3 g |
General specifications
| Minimum operating voltage: | 4.5 V |
|---|---|
| Maximum operating voltage: | 35 V |
| Continuous current per phase: | 4 A1 |
| Maximum current per phase: | 4 A |
| Minimum logic voltage: | 3 V |
| Maximum logic voltage: | 5.5 V |
| Microstep resolutions: | full with 70% current, 1/2, 1/4, 1/8, 1/16, 1/32 |
| Current limit control: | SPI |
| Reverse voltage protection?: | N |
| Header pins soldered?: | N |
Identifying markings
| PCB dev codes: | md52a |
|---|---|
| Other PCB markings: | 0J16036 |
Notes:
Related products
Related categories
Home | Forum | Blog | Support | Ordering Information | Lists | Distributors | BIG Order Form | About | Contact
© 2001–2026 Pololu Corporation
