Motion Control Modules » Brushed DC Motor Drivers » Pololu High-Power Motor Drivers »
Pololu H2 High-Power Motor Driver 36v11 CS
This discrete MOSFET H-bridge motor driver enables bidirectional control of one high-power DC brushed motor. The small 1.3″ × 0.8″ board supports a wide 5 V to 60 V voltage range and is efficient enough to deliver a continuous 11 A without a heat sink. Additional features include reverse-voltage protection and an on-board current sensor that provides a direct measurement of the motor current.
Compare all products in Pololu High-Power Motor Drivers or Single-Channel G2 and H2 High-Power Motor Drivers.
| Description | Specs (13) | Pictures (5) | Resources (4) | FAQs (1) | On the blog (0) | Distributors (33) |
|---|
Dimensions
| Size: | 1.3″ × 0.8″ |
|---|---|
| Weight: | 3.3 g1 |
General specifications
| Motor channels: | 1 |
|---|---|
| Minimum operating voltage: | 5 V |
| Maximum operating voltage: | 60 V2 |
| Continuous output current per channel: | 11 A3 |
| Current sense: | 0.06 V/A4 |
| Minimum logic voltage: | 3.0 V |
| Maximum logic voltage: | 5.5 V |
| Minimum off time: | 300 ns5 |
| Reverse voltage protection?: | Y |
Identifying markings
| PCB dev codes: | md45a |
|---|---|
| Other PCB markings: | 0J14742, blank white box |
Notes:
- 1
- Without included connectors.
- 2
- Absolute maximum; higher voltages can permanently destroy the motor driver. Recommended maximum is approximately 48 V, which leaves a safety margin for ripple voltage on the supply line. Not recommended for use with 48V batteries.
- 3
- Typical results with 100% duty cycle at room temperature.
- 4
- When Vcc = 5 V. Sensitivity is proportional to Vcc.
- 5
- Minimum required for operation below 100% duty cycle; shorter off times can trigger spurious short circuit faults.
Related products
Home | Forum | Blog | Support | Ordering Information | Lists | Distributors | BIG Order Form | About | Contact
© 2001–2025 Pololu Corporation
