Posts by Derrill

You are currently viewing a selection of posts from the Pololu Blog. You can also view all the posts.

Video tutorial: Arduino wiring basics

Posted by Derrill on 29 August 2013

Just getting started with electronics? Take a look at this video to get some tips on keeping your wiring neat and clean using our pre-crimped wires and crimp connector housings.

Featured link: http://www.youtube.com/watch?v=vEHlwq3CHk4

Video tutorial: working with custom cables and connectors

Posted by Derrill on 29 August 2013

In this video, Derek Molloy shows you how to make custom cables using our pre-crimped wires and crimp connector housings and does a great job of showing how to use our crimp tool properly.

Featured link: http://www.youtube.com/watch?v=GkbOJSvhCgU

New Products

Breakout Board for microSD Card with 3.3V Regulator and Level Shifters
12mm Hex Wheel Adapter for 6mm Shaft (2-Pack)
Hakko T18-IS Soldering Tip
Screw Terminal Block: 2-Pin, 0.1″ Pitch, Side Entry (4-Pack)
0.100" (2.54 mm) Low-Profile Male Header: 2×7-Pin, 8.75 mm
RoboClaw 2x5A Motor Controller (V5)
Hakko PN-2002 CHP 5-7/8 in. Needle Nose Pliers
AMIS-30543 Stepper Motor Driver Carrier
Hakko FX-901 Cordless Soldering Iron
30:1 Micro Metal Gearmotor HPCB
Log In
Pololu Robotics & Electronics
Shopping cart
(702) 262-6648
Same-day shipping, worldwide
Menu
Shop Blog Forum Support
My account Comments or questions? About Pololu Contact Ordering information Distributors