Katy Perry peppermint dress with Pololu parts

Posted by Grant on 23 October 2013

Halloween is just around the corner, and people are looking to make fun costumes. I recently took a couple of calls from customers who were looking to make Katy Perry-inspired costume dresses with spinning peppermints, following the instructions found on this RPF forum thread. Parts from Pololu used to make the dress included an enclosed 3-AA battery holder with a switch and a Solarbotics GM3 224:1 Gear Motor. However, we suggest substituting our 200:1 Plastic Gearmotor, which has similar performance but no back shaft that needs to be removed.

If you have a cool costume that uses our products, please feel free to share them in the “Share your projects” section of our Forum.

Featured link: http://www.therpf.com/f24/katy-perry-peppermint-dress-completed-i-think-189238/

0 comments

Post a comment

Using your Pololu account allows you to customize your avatar and manage your comments; you can also post anonymously.

New Products

Zumo 2040 Robot (Assembled with 50:1 HP Motors)
Ribbon Cable with Pre-Crimped Terminals 10-Color M-M 6" (15 cm)
Addressable High-Density RGB 144-LED Strip, 5V, 1m (SK9822)
MinIMU-9 v6 Gyro, Accelerometer, and Compass (LSM6DSO and LIS3MDL Carrier)
3pi+ 2040 Control Board
3.3V Step-Up/Step-Down Voltage Regulator S8V9F3
Motoron M2T550 Dual I²C Motor Controller (Header Pins Soldered)
6V Step-Up/Step-Down Voltage Regulator S8V9F6
Motoron M2U256 Dual Serial Motor Controller (Header Pins Soldered)
ACS724 Current Sensor Carrier -2.5A to +2.5A
Log In
Pololu Robotics & Electronics
Shopping cart
(702) 262-6648
Same-day shipping, worldwide
Menu
Shop Blog Forum Support
My account Comments or questions? About Pololu Contact Ordering information Distributors