Rover 5 chassis with Wild Thumper wheels

Posted by Paul on 31 October 2012

This Arduino-controlled robot commands the Rover 5 chassis and uses a LSM303DLH 3D Compass and Accelerometer Carrier with Voltage Regulators to determine which direction to go. The caterpillar treads were replaced with the Wild Thumper wheels.

Featured link: http://www.youtube.com/watch?v=43zqBtQyBF0

0 comments

Post a comment

Using your Pololu account allows you to customize your avatar and manage your comments; you can also post anonymously.

New Products

CT432-HSWF20DR TMR Current Sensor Compact Carrier 0A to 20A, 5V
0.100″ (2.54 mm) Breakaway Male Header: 1×4-Pin, Right Angle, Black, 50-Pack
Glideforce GF01-122110-1-66 Micro Linear Actuator with Limit Switches: 12V, 8.1kgf, 6mm/s, 100mm Stroke
3.3V, 100mA Step-Down Voltage Regulator D45V1E2F3
JST SH-Style Cable, 4-Pin, Single-Ended Female, 30cm
ACS37030LLZATR-065B3 Current Sensor Large Carrier -65A to +65A, 3.3V
Pololu Ideal Diode Reverse Voltage Protector, 4-60V, 10A
Pololu Power ORing Ideal Diode Pair, 4-60V, 6A
Pololu Isolated Solid State Relay/Switch, SPST, 60V, 7A
ACS37042KLHBLT-010B5 Current Sensor Micro Carrier -10A to +10A, 5V
Log In
Pololu Robotics & Electronics
Shopping cart
(702) 262-6648
Same-day shipping, worldwide
Menu
Shop Blog Forum Support
My account Comments or questions? About Pololu Contact Ordering information Distributors