The Haunted Organist by Mark Goodson

Posted by Paul on 22 December 2009

Customer Mark Goodson constructed this spooky animatronic skeleton using the Jrk USB Motor Controller. See the final result below:

Featured link: http://www.youtube.com/watch?v=wiimQNGnNBY

0 comments

Post a comment

Using your Pololu account allows you to customize your avatar and manage your comments; you can also post anonymously.

New Products

Breakout for JST PH-Style Connector, 4-Pin Male Top-Entry, with SH
JST SH-Style Connector Board for Micro Metal Gearmotors, 2-Pin, Back-Entry (10-Pack)
JST SH-Style Cable, 2-Pin, Female-Female, 25cm
A89301-Based Sensorless Brushless Motor Controller, 50V, 11A
Breakout for JST SH-Style Connector, 3-Pin Male Side-Entry (2-Pack)
RobustMotion RM-EGB Series 24VDC Compact Finger Gripper, 16D, Simple PNP Interface
QTRXL-MD-01RC-S Reflectance Sensor: 1-Channel, 8mm Wide, RC Output, Long Range, Side-Entry Connector
ACS72981ELRATR-200B3 Current Sensor Compact Carrier -200A to +200A, 3.3V
QTRX-MD-01A-S Reflectance Sensor: 1-Channel, 8mm Wide, Analog Output, Low Current, Side-Entry Connector
Breakout for JST PH-Style Connector, 2-Pin Male Top-Entry, with SH
Log In
Pololu Robotics & Electronics
Shopping cart
(702) 262-6648
Same-day shipping, worldwide
Menu
Shop Blog Forum Support
My account Comments or questions? About Pololu Contact Ordering information Distributors