Save 15% on “active” status Pololu-brand products using code MEMORIALDAY26

Using the Pololu Pushbutton Power Switch

Posted by Paul on 22 February 2010

This instructable shows how to power an Arduino through the Pololu Pushbutton Power Switch and use the self-shutoff feature.

Featured link: http://www.instructables.com/id/Using-the-Pololu-Pushbutton-Power-Switch/

0 comments

Post a comment

Using your Pololu account allows you to customize your avatar and manage your comments; you can also post anonymously.

New Products

ACS37100LMATR-050B3 TMR Current Sensor Compact Carrier -50A to +50A, 3.3V
Pololu Isolated Solid State Relay/Switch, SPST, 100V, 4.5A
MP6602 Stepper Motor Driver Carrier (Soldered Header Pins)
Pololu Basic SPDT Relay Carrier with 5VDC Relay, Terminal Blocks, and JST SH-Style Top-Entry Connector
Glideforce GF01-122110-2-66 Micro Linear Actuator with Feedback Potentiometer: 12V, 8.1kgf, 6mm/s, 100mm Stroke
Motoron M3T453 Triple I²C Motor Controller with Soldered Headers
QTR-MD-01RC-S Reflectance Sensor: 1-Channel, 8mm Wide, RC Output, Side-Entry Connector
0.100″ (2.54 mm) Breakaway Male Header: 1×4-Pin, Right Angle, Black, 50-Pack
Pololu Digital Distance Sensor v2, 5cm, Side-Entry Connector
Pololu G2 High-Power Motor Driver 24v30 CS
Log In
Pololu Robotics & Electronics
Shopping cart
(702) 262-6648
Same-day shipping, worldwide
Menu
Shop Blog Forum Support
My account Comments or questions? About Pololu Contact Ordering information Distributors