New quote

Use this form to get a quote and order a Laser-Cut Mylar SMT Stencil.

The file you submit should be of the stencil (also called cream or paste) layer, not the solder mask layer.
The size of your stencil will be computed automatically from the Gerber file.
 
DXF Size: × inches
(rounded up to the nearest inch)

(You can select a turn time or add more stencil designs to your quote after clicking above.)

Pricing: For a turn time of 5 days, the price for one stencil is $25.00 for the first 4 square inches, and $1 for each additional square inch. We round each dimension up to the next whole number, so a 2.1" x 2.1" design would be considered 9 square inches and cost $30. A $10.00 discount is applied to each additional stencil in the order.

Preview Files: After you place your order, we will prepare preview file(s) to show you exactly what we are going to make. When the preview files are ready, we will notify you by email. The email will contain a link to our website, where you must approve the preview file(s) before we can begin the production of your stencil.

New Products

1000:1 Micro Metal Gearmotor HPCB
RoboClaw ST 2x45A Motor Controller (V5, screw terminal I/O)
Vishay TSOP38438 IR Receiver Module, 38kHz
75:1 Micro Metal Gearmotor HPCB
Screw Terminal Block: 7-Pin, 0.1″ Pitch, Side Entry
Addressable RGB 120-LED Strip, 5V, 2m (APA102C)
Screw Terminal Block: 5-Pin, 0.1″ Pitch, Side Entry (2-Pack)
Hakko PN-2002 CHP 5-7/8 in. Needle Nose Pliers
Pololu Dual MC33926 Motor Driver for Raspberry Pi (Assembled)
Hakko T18-IS Soldering Tip
Log In
Pololu Robotics & Electronics
Shopping cart
(702) 262-6648
Same-day shipping, worldwide
Menu
Shop Blog Forum Support
My account Comments or questions? About Pololu Contact Ordering information Distributors