Motion Control Modules » Brushed DC Motor Controllers » RoboClaw Motor Controllers »
VClamp for RoboClaw or MCP Controllers
The VClamp allows RoboClaw and MCP motor controllers to be used with switching power supplies by dissipating excess regenerative energy through a connected external resistor (not included). The VClamp connects directly to the motor power supply and gets logic power and signals from the RoboClaw or MCP controller. The clamping voltage is set in the Basicmicro Motion Studio software, and the board can handle peak voltages and currents up to 60 V and 60 A. A status LED lets you know when the voltage is being clamped.
Compare all products in RoboClaw Motor Controllers or MCP Advanced Motor Controllers.
| Description | Specs (2) | Pictures (3) | Resources (4) | FAQs (0) | On the blog (0) |
|---|
Recommended links
-
Using a voltage clamp with the RoboClaw
Application note for using a VClamp board or voltage clamping circuit with the RoboClaw.
-
VClamp datasheet
Datasheet for the Basicmicro VClamp voltage clamp.
-
Dimention diagram of VClamp
Dimention diagram of the Basicmicro VClamp board.
-
Basicmicro application notes
These application notes from Basicmicro explain their motor controllers and some of their features and modes of operation.
Related categories
Home | Forum | Blog | Support | Ordering Information | Wish Lists | Distributors | BIG Order Form | About | Contact
© 2001–2024 Pololu Corporation
