ISD1932 Voice Recorder Carrier
This breakout board from Sparkfun is a carrier for the ISD1932 multiple-message record/playback IC. It can record up to 64 seconds of voice messages with two different recording trigger modes. The chip has a flexible supply voltage of 2.4 to 5 VDC and breaks out all of the ISD1932’s pins to 0.1"-spaced headers.
|Description||Specs (1)||Pictures (2)||Resources (2)||FAQs (0)||On the blog (0)|
ISD1932 voice recorder carrier top view.
ISD1932 voice recorder carrier bottom view.
This breakout board from SparkFun is a carrier for the ISD1932, a multiple-message record/playback device. This single chip can record up to 64 seconds of voice messages. Microphone inputs and speaker outputs are all handled by the ISD1932. Since this board is a carrier for the ISD1932, careful reading of the datasheet (503k pdf) is recommended.
A switch is connected to allow selection between two of the ISD1932’s operating modes: address trigger or direct trigger. You need to cycle the power after flipping the mode switch to change the mode. The board’s LED will illuminate when the device is recording.
An external resistor is necessary to select the sampling frequency, which in turn determines the recording duration. The duration can range from 21.3 s with a sampling frequency of 12 kHz to 64 s with a sampling frequency of 4 kHz.
The board breaks out all pins of the ISD1932 to 0.1" spaced headers that work with our 0.1" male headers and allow the board to be used with standard breadboards and perfboards. The boards’s headers also work with our 0.1" female headers.
- Operating mode selector switch
- 2.4 to 5 VDC supply voltage
- LED indicates if the board is recording
- Record up to 64 seconds of audio
- All ISD1932 pins broken out to 0.1" headers
- 1.0 x 1.3" (25.4 x 33.02 mm) size
People often buy this product together with:
|0.1" (2.54mm) Crimp Connector Housing: 1x2-Pin 25-Pack|
|ADMP401 MEMS Microphone Breakout Board|
|Pololu Carrier with Sharp GP2Y0D810Z0F Digital Distance Sensor 10cm|