Audio

Products in category “Audio”

Pololu item #: 1484
Brand: Generic
Temporarily out of stock. See product page to backorder.
Out of stock.
Quantity:

This electromagnetic transducer is a compact way to add sound to your embedded project: just supply it with a PWM signal at 3 V to 7 V and it will produce sound at the frequency of the supplied signal from an opening on the side. Since the 70 mA maximum current draw is higher than what can be supplied by a typical microcontroller I/O pin, you will probably want to control it with a suitable driver, such as a small MOSFET.

Pololu item #: 1485
Brand: Generic
Temporarily out of stock. See product page to backorder.
Out of stock.
Quantity:

This electromagnetic transducer is a compact way to add sound to your embedded project: just supply it with a PWM signal at 4 V to 6 V and it will produce sound at the frequency of the supplied signal from an opening on the top. Since the 60 mA maximum current draw is higher than what can be supplied by a typical microcontroller I/O pin, you will probably want to control it with a suitable driver, such as a small MOSFET.

Pololu item #: 1618
Brand: SparkFun
Temporarily out of stock. See product page to backorder.
Out of stock.
Quantity:

Ready to add sound detection to your next project? This small breakout board from SparkFun couples a tiny microelectromechanical system (MEMS) microphone with a 67x gain external amplifying circuit, converting sound into analog voltage signals that can be measured by a microcontroller’s analog-to-digital converter (ADC). The unit comes fully assembled as shown and works from 1.5 to 3.3 V.

Pololu item #: 2744
Brand: SparkFun
Temporarily out of stock. See product page to backorder.
Out of stock.
Quantity:

Make some noise with your next project! The MP3 Trigger board is built to make MP3 sound integration easy. The board has 18 external trigger pins that will directly trigger pre-selected MP3 tracks, and a full-duplex serial control port that provides remote triggering for up to 256 tracks and fast, real-time volume control. MP3s are played from a FAT16 formatted SDSC or FAT32 formatted SDHC micro-SD flash memory cards (required but not included). In addition, it achieves 192 Kbps stereo playback from a wide range of cards.

Pololu item #: 2580
Brand: Verbal Machines
Temporarily out of stock. See product page to backorder.
Out of stock.
Quantity:

The VM-CLAP1 Hand Clap Sensor from Verbal Machines is a low-power, microprocessor-based audio sensor that can detect hand claps or finger snaps while ignoring background noises such as human speech or music. It operates from 2.5 V to 5.5 V and offers a simple interface: when a clap or snap is detected, the output pin goes low for 40 ms, and the integrated blue LED lights up.

Related Categories

Electronics
Log In
Pololu Robotics & Electronics
Shopping cart
(702) 262-6648
Same-day shipping, worldwide
Menu
Shop Blog Forum Support
My account Comments or questions? About Pololu Contact Ordering information Distributors