RGB shoji lamp

Posted by Ben on 23 April 2013

This Japanese-style lamp by Pololu engineer Kevin Chang was made from laser-cut parts and uses an RGB LED Satellite Module 001, a ShiftBar, and a Pololu Mini Maestro 12-channel servo controller.

Here is a video of the lamp in action:

Featured link: http://blog.kevinwchang.com/post/48595870556/rgb-shoji-lamp

0 comments

Post a comment

Using your Pololu account allows you to customize your avatar and manage your comments; you can also post anonymously.

New Products

APM81815 Step-Down Voltage Regulator Carrier, 3.3V Out
12V Step-Up Voltage Regulator U3V9F12
ACS37100LMATR-025B3 TMR Current Sensor Compact Carrier -25A to +25A, 3.3V
ACS37100LMATR-050B3 TMR Current Sensor Compact Carrier -50A to +50A, 3.3V
0.100″ (2.54 mm) Breakaway Male Header: 1×4-Pin, Right Angle, Black, 50-Pack
QTRX-MD-01A-S Reflectance Sensor: 1-Channel, 8mm Wide, Analog Output, Low Current, Side-Entry Connector
Motoron M3T453 Triple I²C Motor Controller with JST SH-Style Connectors and VIN Terminal Block
QTRX-MD-01RC-S Reflectance Sensor: 1-Channel, 8mm Wide, RC Output, Low Current, Side-Entry Connector
Glideforce GF01-121003-2-66 Micro Linear Actuator with Feedback Potentiometer: 12V, 4.3kgf, 17.6mm/s, 30mm Stroke
ACS37100LMATR-025B3 TMR Current Sensor Large Carrier -25A to +25A, 3.3V
Log In
Pololu Robotics & Electronics
Shopping cart
(702) 262-6648
Same-day shipping, worldwide
Menu
Shop Blog Forum Support
My account Comments or questions? About Pololu Contact Ordering information Distributors