Heatsinking an A4988/A4983 stepper motor driver carrier

Posted by Paul on 21 September 2012

This blog post is a very detailed writeup of some A4988 stepper motor driver heatsinking experiments.

Featured link: http://arduinodabbler.wordpress.com/2012/07/13/heatsinking-a-pololu-a4988-a4983-stepper-driver/

0 comments

Post a comment

Using your Pololu account allows you to customize your avatar and manage your comments; you can also post anonymously.

New Products

JST PH-Style Cable, 2-Pin, Female-Female, 25cm
Pololu Reverse Voltage Protector, 4-75V, 17A
12V, 9A Step-Down Voltage Regulator D42V110F12
MP6602 Stepper Motor Driver Carrier
Glideforce GF01-121005-2-66 Micro Linear Actuator with Feedback Potentiometer: 12V, 4.3kgf, 17.6mm/s, 50mm Stroke
TPS2116 Power Multiplexer Carrier with USB Type-C Connector (USB priority)
Motoron M3T453 Triple I²C Motor Controller with JST SH-Style Connectors and VIN Terminal Block
Pololu RC Switch with Isolated Solid State Relay/Switch, SPST, 60V, 6A (Soldered Connectors)
QTRX-MD-01RC-S Reflectance Sensor: 1-Channel, 8mm Wide, RC Output, Low Current, Side-Entry Connector
5V, 600mA Step-Down Voltage Regulator D24V7F5
Log In
Pololu Robotics & Electronics
Shopping cart
(702) 262-6648
Same-day shipping, worldwide
Menu
Shop Blog Forum Support
My account Comments or questions? About Pololu Contact Ordering information Distributors