Flight Testing of a Surrogate UAV at the National Test Pilot School

Posted by Paul on 17 June 2013
Flight Testing of a Surrogate UAV at the National Test Pilot School

This “optionally piloted aircraft” is a Cessna 150 that customer Ryan Olson fitted with an autopilot and remote control system using the Pololu jrk 12v12. It is used for UAV training and development at the National Test Pilot School in Mojave, CA. Ryan’s AUVSI 2012 abstract is available online, and you can see some pictures of the internals below.

Labeled diagram of the inside of Ryan Olson’s optionally piloted Cessna 150.

Jrk 12v12 enclosure used in Ryan Olson’s optionally piloted Cessna 150.

0 comments

Post a comment

Using your Pololu account allows you to customize your avatar and manage your comments; you can also post anonymously.

New Products

Screw Terminal Block: 2-Pin, 0.1″ Pitch, Side Entry (4-Pack)
1000:1 Micro Metal Gearmotor HPCB
Hakko T18-I Soldering Tip
0.100" (2.54 mm) Breakaway Male Header: 1×40-Pin, Straight, Yellow
Hakko FX-888D Digital Soldering Station
Hakko FX-901 Cordless Soldering Iron
RoboClaw 2x30A Motor Controller (V5)
0.100" (2.54 mm) Breakaway Male Header: 1×40-Pin, Straight, Blue
Screw Terminal Block: 7-Pin, 0.1″ Pitch, Side Entry
Hakko FS100-01 Tip Cleaning Paste, 10 g
Log In
Pololu Robotics & Electronics
Shopping cart
(702) 262-6648
Same-day shipping, worldwide
Menu
Shop Blog Forum Support
My account Comments or questions? About Pololu Contact Ordering information Distributors