Comments by Jan S.

  • New version of the Zumo Shield for Arduino - now with full IMU!

    New version of the Zumo Shield for Arduino - now with full IMU!

    - 12 January 2015

    Hi,
    The schematic diagram doesn't list some P/Ns. For example what is the P/N for a boost converter?
    No P/Ns for MOSFETs either.
    As I am starting to experiment with using another microcontroller board with this shield, I can expect anything,
    even burning some parts. It would be good to know the replacements P/N
    Jan

New Products

ISO6542F 4-Channel Digital Isolator Carrier, 2/2, Default Low, Functional Isolation
5V, 600mA Step-Down Voltage Regulator D24V7F5
Breakout for JST SH-Style Connector, 3-Pin Male Side-Entry (2-Pack)
12V, 4.5A Step-Down Voltage Regulator D42V55F12
5V Step-Up Voltage Regulator U3V9F5
5.3V, 6A Step-Down Voltage Regulator D42V55F5.3
QTRX-MD-01RC-S Reflectance Sensor: 1-Channel, 8mm Wide, RC Output, Low Current, Side-Entry Connector
MP6603 Stepper Motor Driver Carrier (Soldered Header Pins)
Glideforce GF01-122110-2-66 Micro Linear Actuator with Feedback Potentiometer: 12V, 8.1kgf, 6mm/s, 100mm Stroke
ACS37030LMYATR-065B3 Current Sensor Large Carrier -65A to +65A, 3.3V
Log In
Pololu Robotics & Electronics
Shopping cart
(702) 262-6648
Same-day shipping, worldwide
Menu
Shop Blog Forum Support
My account Comments or questions? About Pololu Contact Ordering information Distributors