Simple 18-servo hexapod

Posted by Paul on 8 July 2013

This instructable shows how to make a simple 18-servo hexapod robot that uses either just an Arduino or an Arduino and a Maestro to control its servos.

Featured link: http://www.instructables.com/id/Simple-18dof-Hexapod-Arduino-nano-optionally-wit/

0 comments

Post a comment

Using your Pololu account allows you to customize your avatar and manage your comments; you can also post anonymously.

New Products

JST SH-Style Connector Board for Micro Metal Gearmotors, 2-Pin, Back-Entry (2-Pack)
TB67H453FNG Single Brushed DC Motor Driver Carrier
ACS37042KLHBLT-010B5 Current Sensor Micro Carrier -10A to +10A, 5V
JST PH-Style Cable, 5-Pin, Female-Female, 10cm
RobustMotion RM-EGB Series 24VDC Compact Finger Gripper, 20D, Simple PNP Interface
Pololu Power ORing Ideal Diode Pair, 4-60V, 6A
JST SH-Style Cable, 2-Pin, Female-Female, 16cm
Pololu RC Switch with Isolated Solid State Relay/Switch, SPST, 30V, 10A
24V, 4A Step-Down Voltage Regulator D42V55F24
0.100″ (2.54 mm) Breakaway Male Header: 1×4-Pin, Right Angle, Black, 50-Pack
Log In
Pololu Robotics & Electronics
Shopping cart
(702) 262-6648
Same-day shipping, worldwide
Menu
Shop Blog Forum Support
My account Comments or questions? About Pololu Contact Ordering information Distributors