New quote

Use this form to get a quote and order a Laser-Cut Mylar SMT Stencil.

The file you submit should be of the stencil (also called cream or paste) layer, not the solder mask layer.
The size of your stencil will be computed automatically from the Gerber file.
 
DXF Size: × inches
(rounded up to the nearest inch)

(You can select a turn time or add more stencil designs to your quote after clicking above.)

Pricing: For a turn time of 5 days, the price for one stencil is $25.00 for the first 4 square inches, and $1 for each additional square inch. We round each dimension up to the next whole number, so a 2.1" x 2.1" design would be considered 9 square inches and cost $30. A $10.00 discount is applied to each additional stencil in the order.

Preview Files: After you place your order, we will prepare preview file(s) to show you exactly what we are going to make. When the preview files are ready, we will notify you by email. The email will contain a link to our website, where you must approve the preview file(s) before we can begin the production of your stencil.

New Products

RoboClaw Solo 300A, 60VDC Motor Controller
Free Circuit Cellar magazine October 2021
Motoron M2H18v20 Dual High-Power Motor Controller Kit for Raspberry Pi
Zumo 32U4 OLED Robot (Assembled with 100:1 HP Motors)
8-AA Battery Holder, 2×2×2 Arrangement
Free Circuit Cellar magazine May 2022
Free Circuit Cellar magazine April 2022
Free Circuit Cellar magazine December 2021
VL53L5CX Time-of-Flight 8×8-Zone Distance Sensor Carrier with Voltage Regulator, 400cm Max
Zumo 32U4 OLED Robot Kit (No Motors)
Log In
Pololu Robotics & Electronics
Shopping cart
(702) 262-6648
Same-day shipping, worldwide
Menu
Shop Blog Forum Support
My account Comments or questions? About Pololu Contact Ordering information Distributors