Comments by Jan S.

  • New version of the Zumo Shield for Arduino - now with full IMU!

    New version of the Zumo Shield for Arduino - now with full IMU!

    - 12 January 2015

    Hi,
    The schematic diagram doesn't list some P/Ns. For example what is the P/N for a boost converter?
    No P/Ns for MOSFETs either.
    As I am starting to experiment with using another microcontroller board with this shield, I can expect anything,
    even burning some parts. It would be good to know the replacements P/N
    Jan

New Products

JST SH-Style Cable, 2-Pin, Female-Female, 25cm
5.3V, 6A Step-Down Voltage Regulator D42V55F5.3
JST PH-Style Cable, 5-Pin, Female-Female, 10cm
Pololu Digital Distance Sensor v2, 15cm, Side-Entry Connector
Pololu Basic SPDT Relay Carrier with 5VDC Relay, Terminal Blocks, and JST SH-Style Top-Entry Connector
Pololu RC Switch with Isolated Solid State Relay/Switch, SPST, 60V, 6A (Soldered Connectors)
Motoron M3T453 Triple I²C Motor Controller with JST SH-Style Connectors and VIN Terminal Block
TB67H453FNG Single Brushed DC Motor Driver Carrier
ACS37800KMACTR-030B3-I2C Power Monitor Carrier with Secondary I²C Isolation (Soldered Terminal Block, 240VRMS Jumper)
CT220RMV-HS5 Contactless Current Sensor Carrier ±15mT/150G
Log In
Pololu Robotics & Electronics
Shopping cart
(702) 262-6648
Same-day shipping, worldwide
Menu
Shop Blog Forum Support
My account Comments or questions? About Pololu Contact Ordering information Distributors