Freedom track robot

Posted by Paul on 31 May 2013

This robot uses the Track Link and Pin, Injection-Molded Sprocket Set, Tamiya 70097 Gearbox Kit, QTR-8RC Reflectance Sensor Array, and VNH5019 Motor Driver Shield.

Featured link: http://mcuoneclipse.com/2013/05/12/freedom-track-robot-with-ieee802-15-4/

0 comments

Post a comment

Using your Pololu account allows you to customize your avatar and manage your comments; you can also post anonymously.

New Products

Motoron M1U550 Single Serial Motor Controller (Header Pins Soldered)
4.2-15V, 3A Fine-Adjust Step-Down Voltage Regulator w/ Adjustable Low-Voltage Cutoff D30V30MASCMA
Motoron M2T550 Dual I²C Motor Controller
Ribbon Cable with Pre-Crimped Terminals 10-Color M-F 36" (90 cm)
3pi+ 2040 Control Board
LPS22DF Pressure/Altitude Sensor Carrier with Voltage Regulator
3.3V, 2.5A Step-Up/Step-Down Voltage Regulator S13V25F3
Motoron M1U550 Single Serial Motor Controller
298:1 Micro Metal Gearmotor LP 6V with 12 CPR Encoder, Back Connector
12V, 2.8A Step-Down Voltage Regulator D30V30F12
Log In
Pololu Robotics & Electronics
Shopping cart
(702) 262-6648
Same-day shipping, worldwide
Menu
Shop Blog Forum Support
My account Comments or questions? About Pololu Contact Ordering information Distributors