Save 24% on “active” status Pololu-brand products using code MEMORIALDAY24

PiBBOT

Posted by Ryan on 3 May 2013

This balancing robot by Mark Williams is controlled by a Raspberry Pi. The project web page explains the balance control algorithm. PiBBOT uses a Pololu MinIMU-9 v2, metal gearmotors with encoders, and Pololu wheels.

Featured link: http://marks-space.com/2013/04/18/success-with-a-balancing-robot-using-a-raspberry-pi/

0 comments

Post a comment

Using your Pololu account allows you to customize your avatar and manage your comments; you can also post anonymously.

New Products

4.2-15V, 3.3A Fine-Adjust Step-Down Voltage Regulator w/ Adjustable Low-Voltage Cutoff D30V33MASCMA
Ribbon Cable Premium Jumper Wires 10-Color F-F 60" (150 cm)
Graphical OLED Display: 128x64, 1.3", White Pixels, SPI, Black PCB
Ribbon Cable with Pre-Crimped Terminals 10-Color M-F 36" (90 cm)
7.5V, 2.5A Step-Up/Step-Down Voltage Regulator S13V25F7
75:1 Micro Metal Gearmotor HP 6V with 12 CPR Encoder, Back Connector
Motoron M1U550 Single Serial Motor Controller
VL53L7CX Time-of-Flight 8×8-Zone Wide FOV Distance Sensor Carrier with Voltage Regulator, 350cm Max
298:1 Micro Metal Gearmotor LP 6V with 12 CPR Encoder, Side Connector
4.2-15V, 3A Fine-Adjust Step-Down Voltage Regulator D30V30MAS
Log In
Pololu Robotics & Electronics
Shopping cart
(702) 262-6648
Same-day shipping, worldwide
Menu
Shop Blog Forum Support
My account Comments or questions? About Pololu Contact Ordering information Distributors