I've received a couple of the DRV8835 version of this shield and looking at the 5 mm terminal blocks and the "six large through-holes", it seems they don't match up very well. The "large through-holes" are much larger than the pins on the terminal blocks. Is there a trick to soldering these in without either a lot of solder or some melted plastic? I suspect some other terminal block was used in the design of these shields but was changed after the boards were manufactured. If that's true, can you let me know what actually fits the "large through-holes"?
Two new motor driver shields for Arduino
- 28 August 2014I've received a couple of the DRV8835 version of this shield and looking at the 5 mm terminal blocks and the "six large through-holes", it seems they don't match up very well. The "large through-holes" are much larger than the pins on the terminal blocks. Is there a trick to soldering these in without either a lot of solder or some melted plastic? I suspect some other terminal block was used in the design of these shields but was changed after the boards were manufactured. If that's true, can you let me know what actually fits the "large through-holes"?
Thanks,
Corey