Wirelessly-controlled robot with PIC and nRF24L01+

Posted by Jamee on 10 September 2013

In this video, Amjad Al-Ahdal demonstrates his wirelessly-controlled robot with multiple modes that he programmed in C. The robot contains a PIC18F2455 microcontroller, an nRF24L01+ transceiver, a SN754410 motor driver IC, a Pololu wheel and encoder set, and two 100:1 Micro Metal Gearmotors. Its controller has a homemade keypad, another transceiver, a 9DOF sensor, and a serial 16×2 LCD screen.

Featured link: http://www.youtube.com/watch?v=Z1oRE5TTVFU

2 comments

A very special Thanks to Eng. Hamdi Sahloul (^_^)
And also to Teacher Dua'a

Post a comment

Using your Pololu account allows you to customize your avatar and manage your comments; you can also post anonymously.

New Products

12mm Hex Wheel Adapter for 6mm Shaft (2-Pack)
0.100" (2.54 mm) Breakaway Male Header: 1×40-Pin, Straight, Red
30:1 Micro Metal Gearmotor HPCB
Hakko TRR-58-G CHP 6-1/4 in. Macro Flush Cutter
0.100" (2.54 mm) Low-Profile Male Header: 2×7-Pin, 8.75 mm
Hakko T18-IS Soldering Tip
0.100" (2.54 mm) Breakaway Male Header: 2×40-Pin, Right Angle
Hakko PN-2002 CHP 5-7/8 in. Needle Nose Pliers
Hakko T18-D24 Soldering Tip
Hakko 611 Solder Reel Stand (solder not included)
Log In
Pololu Robotics & Electronics
Shopping cart
(702) 262-6648
Same-day shipping, worldwide
Menu
Shop Blog Forum Support
My account Comments or questions? About Pololu Contact Ordering information Distributors