This board from Bodhilabs is a convenient way to add a step-up voltage regulator to your electronics circuit, allowing you to power your digital logic from two-cell battery packs. The board ships with its regulated output voltage set to 5 V, but you can control the output voltage by changing resistor RF2. The rectangular layout allows it to fit the profile of single-cell battery packs.
Discontinuation Notice: This product has been discontinued. Please consider our 5V boost regulator NCP1402 or adjustable boost regulator 2.5-9.5V as an alternative.
The VPack boost regulator provides a constant output voltage between 3 and 6.5 V from a lower input voltage between 1 and 4.5 V, such as you might get from a two-cell battery pack. The unit comes configured to produce an output voltage of 5 V, which is required for TTL digital logic, however resistor RF2 can be changed to adjust the output voltage, such as for 3.3 V applications. Please see the VPack datasheet (95k pdf) for further information. The typical output current is less than 300 mA and is a function of the step-up voltage: the greater the step-up voltage, the less current the unit can supply.
The output voltage typically has a ripple of 100 – 150 mV peak-to-peak; the magnitude is also a function of the step-up voltage. If your application cannot tolerate this ripple, you can decrease it by putting a 100 uF tantalum capacitor between the output and ground.
This board can be purchased by itself or compactly attached to 5V 1-AA. This unit is functionally the same as the square VPack boost regulator from Bodhilabs, but the thinner layout might be more desirable for certain applications. For an even smaller, less expensive 5V boost regulator, please consider our 5V boost regulator NCP1402.
||1.25" x 0.50"
||1 – 4.5 V
||3 – 6.5 V (unit ships with voltage set to 5 V)
|Output voltage ripple:
||100 – 150 mV pk-pk (depends on the step-up voltage)
|Typical output current:
||200 – 500 mA (depends on the step-up voltage)
People often buy this product together with: